Oriental motor BLVD20KM - 12 Inspection and Maintenance; Inspection; Warranty; Disposal

Inspection and maintenance
−63−
12 Inspection and maintenance
12.1 Inspection
It is recommended that periodic inspections would be conducted for the items listed below after each operation of
the motor. If an abnormal condition is noted, discontinue any use and contact your nearest Oriental Motor sales oce.
Note
•
Do not conduct the insulation resistance measurement or dielectric strength test with the motor and
driver connected. Doing so may cause damage to the product.
•
The driver uses semiconductor elements, so be extremely careful when handling them. Static electricity
may damage the driver.

Inspection item
•
Check if any of the mounting screws for the motor and gearhead is loose.
•
Check if the bearing part (ball bearings) of the motor generates unusual noises.
•
Check if the bearing part (ball bearings) or gear meshing part of the gearhead generates unusual noises.
•
Check if the output shaft of the motor and gearhead and a load shaft are out of alignment.
•
Check if a damage or stress is applied on the cable or the connection part between the cable and driver is loose.
•
Check if the openings in the driver are clogged.
•
Check if any of the driver mounting screws or the screws of the main power supply input terminal is loose.
•
Check if there is any abnormality or unusual smell inside the driver.
12.2 Warranty
Check on the Oriental Motor Website for the product warranty.
12.3 Disposal
Dispose the product correctly in accordance with laws and regulations, or instructions of local governments.