Oriental motor US2D6-JA - Operating with External Signals

Convenient functions
−
22
−
6.7 Operating with external signals
When the motor operation/standstill and rotation direction change are performed by ON/OFF-control of the input signals,
disable the operation switch and rotation direction switch.
When the motor is operated externally, set the "external operation signal input" parameter to "
rE
."
If the operation switch or rotation direction switch is operated when the "external operation signal input" parameter is set to
"
rE
," "
rE
" is displayed for about 1 second.
ON
OFF
ON
OFF
REV input
FWD input
Motor movement
Forward direction
Reverse direction
Operation/standstillOperation/standstill
FWD input REV input Motor shaft action
ON OFF
Rotates in the
forward direction
OFF ON
Rotates in the
reverse direction
OFF OFF
Standstill
ON ON
The motor rotation direction varies depending on the
gear ratio of the gearhead or the setting of the rotation
direction switch. Refer to p.17 for rotation direction of the
motor.
Note
To change rotation direction of the motor, wait until the motor completely stops. If the rotation direction is
switched while the motor is operating, it may not change, or it may take a long time to change.