Oriental motor US2D6-JA - Product Specifications; Model and General Specifications

Specications
−
31
−
12 Specications

Specications
Model
US2-

o
JA-____ US2-

o
UA-____ US2-

o
JC-____ US2-

o
EC-____
Speed controller model
US2D
o
-JA_ US2D
o
-UA US2D
o
-JC_ US2D
o
-EC
Motor output power 6 W, 15 W, 25 W, 40 W, 60 W, 90 W
Power supply voltage
Single-phase
100 VAC
Single-phase
110/115 VAC
Single-phase
200 VAC
Single-phase
220/230 VAC
Frequency 50/60 Hz 60 Hz 50/60 Hz 50/60 Hz
Variable speed range 50Hz: 90 to 1400 r/min 60Hz: 90 to 1600 r/min
Function
Monitor Rotation speed, Input signal
Parameter
Speed reduction ratio, speed increasing ratio, lowest digit display xing,
prevention of operation at power-on alarm, external operation signal input,
acceleration/deceleration time, speed upper and lower limit, initialization
Other Prohibiting data editing
Input signal 2 photocoupler inputs FWD input, REV input
Protective functions
When any of the following protective functions is activated, the speed controller shuts
off the power to the motor, and the motor coasts to a stop.
At the same time, the alarm code will be shown on the display of the operation panel.
Alarm type: Motor overheat, motor lock, motor poor connection, EEPROM error,
prevention of operation at power-on
o
in the model names indicates a number representing the motor output power.

in the model names indicates a number
representing the frame size of the motor.
For the specications such as the torque, rotation speed, etc. of the products, check the Oriental Motor Website or catalog.

General specications
Item Motor Speed controller
Operation
environment
Ambient temperature
Single-phase 100 VAC,
Single-phase 200 VAC:
−10 to +50 °C [+14 to +122 °F]
(non-freezing)
Single-phase 110/115 VAC,
Single-phase 220/230 VAC:
−10 to +40 °C [+14 to +104 °F]
(non-freezing)
0 to +50 °C [+32 to +122 °F]
(non-freezing)
Ambient Humidity 85% or less (non-condensing)
Altitude Up to 1000 m (3300 ft.) above sea level
Surrounding atmosphere
No corrosive gas, dust, water or oil.
Cannot be used in radioactive materials, magnetic eld, vacuum or other
special environment.
Vibration
Not subject to continuous vibrations or excessive impact.
In conformance with JIS C 60068-2-6 "Sine-wave vibration test method"
Frequency range: 10 to 55 Hz, Pulsating amplitude: 0.15 mm (0.006 in.)
Sweep direction: 3 directions (X, Y, Z), Number of sweeps: 20 times
Storage
environment
Ambient temperature −25 to +70 °C [−13 to +158 °F] (non-freezing)
Ambient Humidity 85% or less (non-condensing)
Altitude Up to 3000 m (10000 ft.) above sea level
Surrounding atmosphere
No corrosive gas, dust, water or oil.
Cannot be used in radioactive materials, magnetic eld, vacuum or other
special environment.
Shipping
environment
Ambient temperature −25 to +70 °C [−13 to +158 °F] (non-freezing)
Ambient Humidity 85% or less (non-condensing)
Altitude Up to 3000 m (10000 ft.) above sea level
Surrounding atmosphere
No corrosive gas, dust, water or oil.
Cannot be used in radioactive materials, magnetic eld, vacuum or other
special environment.
Degree of protection IP20