Oriental motor US2D6-JA - Regulatory Compliance; Directive Compliance and Temperature Tests

Standard and CE Marking
−
28
−

Low Voltage Directive
•
This product is designed and manufactured to be incorporated in equipment.
•
This product cannot be used in IT power distribution systems.
•
Install the product inside an enclosure in order to avoid contact with hands.
•
Be sure to ground the Protective Earth Terminal of the motor.
•
Isolate the motor cable, power supply cable and other drive cables from the input signal cable (TB1) by means of double
insulation.
Applicable Standards
•
Motor
Parallel shaft·combination type, Round shaft type : EN 60034-1, EN 60034-5, EN 60664-1, EN 60950-1
Right angle·geared type : EN 60034-1, EN 60034-5, EN 60664-1
•
Speed controller : EN 50178
Momentary excess torque based on EN 60034-1
Motor model Momentary excess torque
Momentary excess torque represents a maximum torque that can
maintain the operation for 15 seconds without stalling or abrupt
speed change even if the torque is increased gently while operating
at rated voltage and rated frequency.
SCM315
,
SCM560
120% of the rated torque
SCM26
,
SCM425
SCM540
,
SCM590
130% of the rated torque
Installation conditions (EN Standard)
Motor Speed controller
Overvoltage category:
Ⅱ
Pollution degree: 2
Protection against electric shock: Class
Ⅰ
Overvoltage category:
Ⅱ
Pollution degree: 2
Protection against electric shock: Class
Ⅱ
If the overvoltage category
Ⅲ
and pollution degree 3 are required for the equipment, install the motor and speed controller
in an enclosure whose degree of protection is equivalent to IP54 or higher, and supply a rated voltage via the insulation
transformer.

The motor temperature rise tests
Temperature rise tests required by the above standards are performed in a state that has been attached a heat radiation plate
instead of a gearhead. The size and material for the heat radiation plates are as follows.
Parallel shaft·combination type,
Round shaft type
Right angle·geared type
Motor
model
Size
[mm (in.)]
Thickness
[mm (in.)]
Material
Motor
model
Size
[mm (in.)]
Thickness
[mm (in.)]
Material
SCM26
115×115
(4.53×4.53)
5 (0.20)
Aluminum
alloy
SCM425
SCM540
SCM590
200×200
(7.87×7.87)
5 (0.20)
Aluminum
alloy
SCM315
125×125
(4.92×4.92)
SCM425
135×135
(5.31×5.31)
SCM540
165×165
(6.50×6.50)
SCM560
SCM590
200×200
(7.87×7.87)
Thermal class: 130 (B)

EMC Directive
This product has received EMC compliance under the conditions specied in "Example of installation and wiring" on p.30.
Since the nal level of conformance of the mechanical equipment to the EMC Directive will vary depending on such factors
as the conguration, wiring, layout and risk involved in the control-system devices and electrical parts that are used with the
motor/speed controller, the customer must conduct the EMC tests on the mechanical equipment to conrm compliance.
Applicable Standards
EMI Emission Tests
Harmonics Current Test
Voltage Fluctuations Test
EN 61000-6-4
EN 61000-3-2
EN 61000-3-3
EMS Immunity Tests EN 61000-6-2
This type of PDS is not intended to be used on a low-voltage public network which supplies domestic premises; radio
frequency interference is expected if used on such a network.