Orion OPM-4260 - DVI Converter Tracking and PIP Features; Tracking Control and PIP Functionality

- 64 - - 65 -
(12) Tracking
• Control the Screen size, sharpness, and position of DVI Converter for PC input mode.
• In case alignment doesn't work through "Tracking Auto" command, users can tune finely
through "Manual Tracking".
• "Manual Tracking" window enables users to set Frequency, Phase, LineStart and PixelStart.
• Detail adjustment steps are as follows.
1) Tune "Phase" until the vertical lines are clearly adjusted..
2) Tune "LineStart" to adjust vertical alignment. "PixelStart" for horizontal alignment.
3) Adjust "Frequency" if alignment is still wrong.
If you adjust "Frequency", repeat step 1) and 2) to fit alignment.
Adjustable range is as follows
• Frequency : The range of "Frequency" you can adjust is -50 to 50
• Phase : The range of "Phase" you can adjust is 0 to 63
• Linestart : The range of "Linestart" you can adjust is -23 to 10
• Pixelstart : The range of "Pixelstart" you can adjust is -50 to 40
• Auto Tracking : Automatic alignment for DVI Converter screens.
• Auto Calibration : Automatic color control for DVI Converter screen.
(13) PIP( Picture In Picture )
• A variety of images can be displayed with the PIP function of DVI converter. To activate PIP,
click "PIP" in the Mode. The position of sub-picture can be controlled by clicking - / + buttons
increase or decrease the number or directly type in the numbers at Edit box.
• Various input sources can be used. To set the sub-input, click the sub-input combo box and
select sub-input.
• Main screen and sub-screen can be swapped with the PIP Swap function. Press "ON" button
at the right side of "PIP Swap." If you want to return to previous screen, press "OFF" button at
the right side of "PIP Swap."
• Mode : Normal mode - Normal screen without PIP (PIP Off)
PIP mode-Sub-screen is displayed at the lower right corner of the screen. (PIP On)
• Position : Horizontal - Adjust the horizontal location of PIP. Adjustable range 0~100
Vertical - Adjust the vertical location of PIP. Adjustable range 0~100
• Sub Input : Set the input for PIP. One of DVI, HDMI, HDSDI, PC, DTV, S-VIDEO, and VIDEO
can be selected for sub-input.
※ According to the main input, the sub-input can be restricted. If the main input is a digital input such as
DVI, HDMI or HD-SDI, the sub-input should be an analog input such as PC, DTV, S-VIDEO or Video. If
the main input is an analog input the sub-input should be a digital input.
• PIP Swap : OFF - Return to previous locations of swapped Main Source Input screen and
Sub Source Input screen.
ON - Exchange the locations of Main Source Input screen and Sub Source Input
screen.
OPM-4260 | OPM-4260R
Innitely Expandable