OTT netDL 1000 - Page 2

60 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

We reserve the right to make technical changes and improvements without notice.

Table of Contents

Default Chapter3
- Table of Contents3
Scope of Supply5
Order Numbers and Version Code5
General Safety Information7
About These Operating Instructions8
Introduction9
- Overview of the OTT Netdl IP Datalogger12
Overview: Starting up the OTT Netdl Unit14
Installing the OTT Netdl Unit15
- Attaching the OTT Netdl Unit15
- Device Versions B . . and C . . : -30 °C up to +70 °C15
- Attaching the Datalogger15
- Locations of the Screw Terminal Strips and RS-232 Interfaces17
- Connecting Sensors Having an RS-485 Interface (2-Wire)18
- Connecting Sensors Having an SDI-12 Interface19
- Connecting Sensors Having a Pulse Output20
- Connecting Equipment Having a Status Output20
- Connecting Sensors Having a Voltage Output21
- Connecting Sensors Having a Current Output21
- Connecting the Pt 100 Temperature Sensor22
- Connecting Sensors Having a Potentiometer (5 Kohms)22
- Connecting Sensors Having an RS-232 Interface23
- Connecting Switching Contacts23
- Connecting 4-20 Ma Outputs24
- Connecting Status Outputs25
- Connecting the Power Supply to the OTT Netdl Unit25
- Connecting the GSM Cellular Radio Antenna and Inserting the SIM Card26
- Connecting the GSM Cellular Radio Antenna26
- Connecting External Communication Equipment27
- Connecting an Ethernet LAN or DSL Router28
- Connecting to the USB Device Interface28
Setting OTT Netdl Operating Parameters29
- Installing the OTT Data Logger Operating Program29
- Establishing the PC/OTT Netdl Communication Link (on Site)29
- Introduction: Setting OTT Netdl Operating Parameters31
Operating/Configuring the OTT Netdl Unit on Site32
- Determining and Displaying Instantaneous Values (Observer Function)32
- Entering Observer Texts (Extended Observer Function)34
- Scaling Instantaneous Values/Stored Values (Set Offset)35
- Displaying/Setting Date and Time36
- Entering Manual Values into a Manual Sensor36
- Displaying Information on Transmissions over the Internet37
- Displaying Information on Connections38
- Displaying System Information39
- Starting the Voice Announcer (on Site)40
LED Indicators41
Reading out Measured Data on Site42
Updating the OTT Netdl Firmware43
Overview: Alarm and Action Management44
Protecting the OTT Netdl Unit Using a Password45
Deleting the Data Memory46
Setting Date and Time46
Creating and Printing the Terminal Connection Diagram47
Creating and Printing a Device View47
OTT-SDI Transparent Mode48
Voice Announcer Functionality Overview50
Error Messages51
- Internal Error Messages51
- External Error Messages51
- Sensor Error Messages51
- Processing Module Error Messages52
Maintenance53
Repair53
Note on the Disposal of Old Units54
Technical Data55
Appendix A: OTT Netdl 500 /OTT Netdl 1000 Declaration of Conformity58

Related product manuals

Preview: OTT netDL 500