Press jog shuttle to jump to the next character position, etc.
After entering the manual value, the time applicable to it is entered from left to
right. The character to be changed in each case is shown inverted (white on
black background) and flashing: The OTT netDL shows the current time as the
default.
Rotate jog shuttle until required character appears.
Press jog shuttle to jump to the next character position, etc.
Confirm the entry: Press jog shuttle (√). (Cancel: Rotate jog shuttle to ≈ and
press.)
To enter manual values of additional channels, rotate jog shuttle to ¥ and press.
Then return to step 5 and repeat. After the last manual value has been entered,
the LCD display shows the first channel again.
Finish entering manual values: Rotate jog shuttle to ≈ and press (twice); then
rotate jog shuttle to the
End position and press ("Manual sensor" present:
Rotate jog shuttle to ≈ and press; then rotate jog shuttle to the
End position
a
nd press; then repeat complete procedure). If the jog shuttle is not used for
three minutes, the LCD display shuts off automatically.
Note
The OTT netDL unit saves a manual sensor in the same way as a normal
aperiodic sensor, together with measured value, date and time.
9.6 Displaying information on Internet transmissions
A transmission is a remote data transfer that is configured in the Bedienprogramm
and which the OTT netDL unit independently executes over a specified communi-
cation path. The
LCD display shows information only through the "Internet" comuni-
cation path
!
How to display information on Internet transmissions:
Press jog shuttle twice. (Between the first and second presses, the
LCD display
shows the OTT netDL firmware version.)
The OTT netDL unit activates the
LCD dis-
play
and shows the selection menu (if password protection for the LCD display
is active ➝ enter the four-digit password first; refer to online help).
Rotate jog shuttle to Information and press.
Press jog shuttle (Transmissions).
➝ The LCD display showsinformation on the first transmission:
Line 1: Name of the transmission;
Line 2: Interface and unit through which the data transmission takes place:
Line 3: Date and time of the last transmission through this communication
path.
Show other transmissions: Rotate jog shuttle to ¥ and press.
Exit display: Rotate jog shuttle to ≈ and press; then rotate Jog shuttle twice to
End and press. If the jog shuttle is not used for three minutes, the LCD display
shuts off automatically.
37
To Next Page
Loading...
Need help?
General
