Need help?Do you have a question about the OTT netDL 1000 and is the answer not in the manual?
General| Category | Data Loggers |
|---|---|
| Manufacturer | OTT Hydromet |
| Measurement Parameters | Water level, temperature |
| Measurement Range (Water Level) | 0 to 10 m |
| Accuracy (Temperature) | ±0.1 °C |
| Resolution (Temperature) | 0.01 °C |
| Protection Class | IP67 |
| Power | Battery or external power supply |
| Operating Temperature | -20°C to +60°C |
| Inputs | SDI-12 |
| Measurement Range (Temperature) | -20 to +60 °C |
| Resolution (Water Level) | 0.1 mm |
| Data Interface | USB, SDI-12 |
| Power Supply | Internal battery or external power |
| Communication | SDI-12 |
| Accuracy (Water Level) | ±0.05% FS (pressure sensor dependent) |
Steps for physically mounting the OTT netDL unit, including requirements for installation sites.
Instructions for connecting the GSM antenna and inserting the SIM card for device versions B and C.
Guide for connecting the OTT netDL 1000 unit to a network via its Ethernet interface.
Instructions for setting up a communication link between a PC and the OTT netDL unit via serial or USB.
Procedure for determining and displaying current sensor readings using the Observer function.
How to adjust or offset measured values to match specific sensor scales or requirements.
Details on error codes and messages generated by connected sensors.
To Next Page
