36
9.4 Displaying/setting date and time
How to set the date and time:
Press jog shuttle twice. (Between the first and second presses, the LCD display
shows the OTT netDL firmware version.) The OTT netDL unit activates the LCD dis-
play and shows the selection menu (if password protection for the LCD display is
active
➝
enter the four-digit password first; refer to
online help
).
Rotate jog shuttle to SettinÌs and press.
Press
jog shuttle
(Date/Time) ➝ the OTT netDL unit shows the current time
and date.
How to set the date and time:
Press jog shuttle (√).
Change number: Rotate jog shuttle.
Jump one number to the right : Press jog shuttle. After moving to the seconds,
the OTT netDL shows √ and ≈.
Set date/time (store): Press jog shuttle (√). (Cancel: rotate jog shuttle to ≈ and
press.)
Finish display: Rotate jog shuttle to ≈ and press; then rotate jog shuttle three
times to the
End position and press. When the jog shuttle is not used for three
minutes, the LCD display shuts off automatically
Alternatively, the date and time can be set via the operating program: "OTT netDL
menu, "Date / time" function.
Note
The operating program may partly or fully disable the date and time setting
option.
9.5 Entering manual values into a manual sensor
Requirements
The configuration of a channel that is to allow the entry of manual values must
include the "Manual Sensor" function block (refer to online help).
How to enter manual values:
Press jog shuttle twice. (Between the first and second presses, the
LCD display
shows the OTT netDL firmware version.)
The OTT netDL unit activates the
LCD dis-
play
and shows the selection menu (if password protection for the LCD display
is active ➝ enter the four-digit password first; refer to online help).
Press jog shuttle (Observer). The
LCD display
shows the station name, the sta-
tion number, the current time and, after 2 seconds, the level of the voltage supply.
Rotate jog shuttle to ! and press.
When the Extended observer feature is enabled in the OTT netDL con -
figuration (the LCD display first shows a selection window): Rotate jog shuttle to
Manual Sensor and press.
The LCD display shows the first sensor for manual input. Rotate jog shuttle
to √. To enter manual values of additional channels, press jog shuttle (¥).
To start manual input, press jog shuttle (√).
The manual value is now entered by character from right to left. The character
to be changed in each case is shown inverted (white on black background)
and flashing.
Rotate jog shuttle until required character appears.
To Next Page
Loading...
Need help?
General
