Otto Bock B400 - Transportation and Storage

06/2011 B400Page 92
Transportation and Storage
To do so, remove the fuse from the protective cover on the
control panel, open the cap of the safety holder and insert
the fuse.
Make sure that the fuse is pressed into the centre of the
spring contacts and that it is not at an angle. Close the cap
until you feel it snap back into place.
1 2 3
Fig.4 Fuseholder
1 Cap, open
2 Fuse, inserted
3 Fuse holder
5 TransportationandStorage
WARNING
Risk of accident and injury due to improper use for
transportationinwheelchairaccessiblevehicles.
The power wheelchair may only be used for transportation
in a wheelchair accessible vehicle if the safety compo-
nents (such as lap belt) which are offered by Otto Bock
and suitable restraint systems are used.
Only one person may be transported in the B400 at any
one time. For optimum protection of the occupants in case
of an accident, use the seats and corresponding restraint
systems installed in a wheelchair accessible vehicle while
it is in operation.
For more information on the use of the B400 as a seat in a
wheelchair accessible vehicle, please refer to our bro-
chure “Using your Wheelchair / Mobility Base with Seat-
ing Shell or Buggy for Transportation in Wheelchair Ac-
cessible Vehicles”, order number 646D158.
CAUTION
Riskofinjuryasaresultofnotengagingthelockssuf-
ficiently.Secure the power wheelchair during transport in