Otto Bock B400 - Accessories; 7.1 Mechanical Seat Tilt

06/2011
B400
Page 111
Operation
Indication Function
Red LED is flashing
Battery defective or missing, or
charging time exceeded
Table5 Batterychargingstatusesduringthechargingprocess
If none of the LEDs are lit, there is no power supply.
7 Accessories
CAUTION
Risk of injury due to unsecured screw connections.
After loosening screw connections with thread lock, re-
place these screw connections with new ones or secure
them with medium-strength thread lock substance (e.g.
EuroLock A24.20).After the power wheelchair has been
set and adjusted, the attachment screws and/or nuts must
be firmly retightened. During tightening observe torques
when specified.
INFORMATION
Only original options provided by the manufacturer may
be used. The optional components may be mounted only
as described here. Failure to comply will void the warranty.
INFORMATION
All available optional components are contained on the
order form and in the wheelchair accessories catalogue.
The B400 power wheelchair has been designed as a modu-
lar system. Certain component groups can be exchanged
and other accessory components can be added to the
power wheelchair. The complete range of options is listed
on the order form and in the wheelchair accessories cata-
logue.
7.1 MechanicalSeatTilt
WARNING
Riskofpinchingorcrushingthefingers. Do not reach
into the danger zone between the frame and the seat
when tilting the seat. There must not be any interfering
objects or obstacles in the tilting area.
WARNING
Riskofinjuryifthepowerwheelchairtipsoverduring
driving. Before driving up slopes or over obstacles, the
back must be brought into the upright position.