OUMAN H23 User Manual

7.9 Create backup and Restore backup
7.8 Restore factory settings
When you return the factory settings, the controller takes into use
those control circuits, which were in use before factory reset. The
restoring factory settings is done in System settings by pressing
the OK-button down for an extended period of time (Backup-menu
appears to System settings).
Create backup
To the device memory >
To the memory card >
H23
Create backup
Software updates
Restoring backup is done in System settings by pressing the OK-
button down for an extended period of time (Backup-menu ap-
pears to System settings. If you created a backup, you can restore
the backup by pressing OK. You can restore the backup from the
memory card or from the internal memory.
Backup is done in System settings by pressing the OK-button down
for an extended period of time (Backup-menu appears to System
settings).
Create a backup, when H23 has been configured and the device-
specific settings have been set.
If desired, also the factory settings can be restored to the device.
All the parameters which are saved in the non-volatile memory will
be included in the backup. Such parameters are e.g. all the setting
values and time programs. The backup can be saved to the internal
memory or to micro SD memory card. Memory card backups can be
copied from one device to another.
1. Remove microSD memory card from H23.
2. Wait until error message “Memory card error!” is shown in the
display
3. Insert new microSD memory card which includes new software
to H23.
4. H23 asks if you want to save existing device configuration to be
taken in use after the update.
5. H23 requests reboot to start the update of the new software. The
updating of the software takes few minutes. The display will flash
during the update process.
Restore backup
From the device internal memory >
From the memory card >
Restore backup
System settings
Lock code Not in use >
Restore factory settings >
Restore backup >
Create backup >
It is recommended to create a backup of the system before softwa-
re update. The software update is done with following steps:
memory card
24

OUMAN H23 Specifications

General

Brand	OUMAN
Model	H23
Category	Controller
Language	English