To avoid any possible damage to the device, and probe, keep these items FAR AWAY from sprays,
liquids, or solvents.
Surface Cleaning
As per the operation condition requirements, DO check the device and probe surface from time to
time.
When cleaning the device / probe surface, please follow up with operation steps as follows -
i. Before the surface cleaning, making sure the device been powered off, without any
accessory / outer communicating facility connected; making sure probe not working with the
device / outer communicating facility.
ii. Use non-electrostatic soft cloth to remove the surface dust.
iii. For further surface cleaning, recommend to use a wet-but-no-water-dripping soft
cloth, or soft detergent.
Note: To avoid permanent damage to the surface of device and probe, DO NOT introduce any corrosive chemical
cleaner / detergent.
Warning:
After device surface cleaning, before working the device for next time, please
confirm that the device surface in a relative dry condition, so as to avoid any
possible short circuit risk, or possible human body injury caused by electric
Conduction from the wet surface.
To Previous Page
Loading...
Need help?
General
