Turns on or off the display of all marker table.
5.15 【Marker→】
A soft menu associated with the marker function is popped out for
setting the other system parameters (such as Center frequency,
Reference level) by current marker readings. These menus relate
to the frequency of the spectrum analyzer, whether the sweep
width and marker are in normal or delta marker mode.
5.15.1 [Mkr->CF]
Sets the center frequency of the analyzer based on the frequency
of the current marker. This feature quickly moves the signal to the
center of the screen.
⚫ If Normal is selected, the center frequency will be set to the
frequency of the current marker.
⚫ If Delta Marker is selected, the center frequency will be set to the
frequency at which the Delta Marker is located.
⚫
The function is invalid in Zero span mode.
5.15.2 [Mkr->CF Step]
Sets the center frequency step of the analyzer based on the
frequency of the current marker.
⚫ If Normal is selected, the center frequency step will be set to the
frequency of current marker.
⚫ If Delta Marker is selected, the center frequency step will be set
to the frequency at which the Delta Marker is located.
⚫ The function is invalid in Zero span mode.
5.15.3 [Mkr->Start]
Sets the start frequency of the analyzer based on the frequency of
the current marker.
⚫ If Normal is selected, the start frequency will be set to the
frequency of the current marker.
⚫ If Delta Marker is selected, the start frequency will be set to the
To Next Page
Loading...
Need help?
General
