5.18 【Meas Setup】
Measurement setting menu for the corresponding measurement
parameter settings when adjacent channel power, channel power,
occupied bandwidth measurement mode is turned on.
5.18.1 [Channel BW]
Set the bandwidth of the channel power measurement, and set the
total display power percentage of bandwidth.
5.18.2 [Channel Interval]
Set the center frequency difference of the primary channel to the
adjacent channel.
5.18.3 [Channel Nums]
Set the number of upper and lower adjacent channels measured
by adjacent channel power.
5.18.4 [Power Percent]
Set the power ratio of occupied bandwidth.
5.19 【System】
A soft menu for system parameter settings pops up. Including
[System ►], [ Setting ►], [PowerOn / Preset ►], [ Calibration ►].
For first time you use the spectrum analyzer, set the date and time,
the system will store the settings, restart the machine after power
off won’t change the settings.
5.19.1 [System►]
To Next Page
Loading...
