frequency at which the Delta Marker is located.
⚫ The function is invalid in Zero span mode.
5.15.4 [Mkr->Stop]
Sets the stop frequency of the analyzer based on the frequency of
the current marker.
⚫ If Normal is selected, the stop frequency will be set to the
frequency of the current marker.
⚫ If Delta Marker is selected, the stop frequency will be set to the
frequency at which the Delta Marker is located.
⚫ The function is invalid in Zero span mode.
5.15.5 [Mkr->Ref Level]
Sets the reference level of the analyzer based on the amplitude of
the current marker.
⚫ If Normal is selected, the reference level will be set to the
amplitude of the current marker.
⚫ If Delta Marker is selected, the reference level will be set to the
amplitude at which the Delta Marker is located.
5.15.6 [MkrΔ->Span]
Changes the span of the analyzer to the frequency difference
between the two markers.
5.16 【Marker Fctn】Marker Function
Executes specific marker soft menu.
5.16.1 [Function Off]
Turn off marker measurement function.
5.16.2 [NdB On Off]
Enables the N dB BW measurement or sets the value of N. The N
dB BW denotes the frequency difference between points that are
To Next Page
Loading...
Need help?
General
