Tracking source network measurement function, mainly for
amplitude and frequency characteristics measurement; RF output
and spectrum measurement is fully synchronized, can be used as
a scalar network analyzer. When the network measurement
function is "on", the measurement results show relative values after
"normalized", expressed in "dB". When the network measurement
function is "off", the measurement shows the spectrum
measurement result, expressed in "dBm".
2) [Output Level]
Used to set the output power of the trace source.
3) [Ref Level]
This soft menu is used to track the source network measurement of
the user to adjust the measurement results display location.
4) [Position]
Used to set the position during network measurement.
5) [Execute Norm]
This soft menu is used to track the user's field calibration of the
source network measurements. After connecting the instrument's
RF output to the RF input, press the "normalized" soft menu and
the display shows a straight line on the 0dB scale.
6) [Normalize On Off]
This soft-menu is used to turn normalization on or off after
executing normalization.
7)[Return]
Return to the previous menu.
5.12 【Demod】Demodulation
Enter the demodulation settings, the spectrum analyzer supports
audio demodulation and analog demodulation.
To Next Page
Loading...
Need help?
General
