5.13 【Peak】
Executes peak searching immediately and opens the Peak setting
menu.
Key Points:
⚫ If Max is selected from the Peak Search option, it will search and
mark the maximum on the trace.
⚫
The peak search of Next Peak, Peak Right, Peak Left or peaks
in the peak table must meet the specified parameter condition.
⚫
The spurious signal at the zero frequency caused by LO feed
through is ignored.
5.13.1 [Max Search]
Place a frequency scale at the highest point of the trace and
display the frequency and amplitude of the frequency scale in the
upper right corner of the screen. [Max search] does not change the
activated function.
5.13.2 [Next Peak]
Searches the peak whose amplitude is the closest to that of the
current peak. The peak is then identified with a marker. When this
key is pressed repeatedly, you can quickly find a lower peak.
5.13.3 [Left Peak]
Searches the nearest peak located to the left side of the current
peak and meets the current peak and peak thresholds condition.
The peak is then identified with a marker.
5.13.4 [Right Peak]
Searches the nearest peak located to the right side of the current
peak and meets the current peak and peak thresholds condition.
The peak is then identified with a marker.
5.13.5 [Min Search]
To Next Page
Loading...
Need help?
General
