5.17.5 [OBW On Off]
Turn on or off the occupied bandwidth measurement. Press
【Meas Setup】 to pop up the parameter setting soft menu for
occupying the bandwidth measurement. Occupied Bandwidth is a
measure of the bandwidth occupied by the transmitter signal can
be measured from the total power ratio within the in-band power
span, with a default value of 99% (the user can set this value).
5.17.6 [Pass-Fail►]
Enter the pass / fail measurement function soft menu. Pass / fail
measurement has two modes of window measurement and area
measurement.
5.17.6.1 [Window Meas►]
Enter Window measurement soft menu.
1) [Window Meas On Off]
Turn on or off window measurement mode.
2) [Limit Line On Off]
Turns the amplitude line on or off, and the amplitude line turns on
when the window measurement is on.
3) [Freq Line On Off]
Turns the frequency line on or off, and the frequency line turns on
when the window measurement is on.
4) [Limit Set Up Low]
Used to edit the upper and lower limit on the amplitude line.
5) [Freq Set Start Stop]
Start and stop frequencies for scanning line for editing.
6) [Window Sweep On Off]
Turns window sweep on or off. When the window sweep is on, only
the window formed by the intersection of the amplitude line and the
To Next Page
Loading...
Need help?
General
