Pacific Power Source UPC-32 - Output Power Form Control Specifications; Phase Angle Control Specifications; Waveform Synthesis Specifications

SECTION 2 SPECIFICATIONS
11
2.1.6 OUTPUT POWER FORM CONTROL SPECIFICATIONS
The UPC-32 can create single (one), split (two), or three phase waveforms with ФB and ФC at any phase
angle referenced to phase A.
The UPC-12 generates only one output vector. When used in an AMX or ASX Power Source, it may
generate single (one) and split (two) phase output.
When two phase output form is selected, the hardware in the power source causes the ФB signal to be
180° out of phase with the ФA signal. The user may program 240 VAC with a result of 120 VAC from ФA
to neutral and 120 VAC from ФB to neutral and 240 VAC from ФA to ФB.
2.1.7 PHASE ANGLE CONTROL SPECIFICATIONS
The phase angle displacement of the UPC-32 oscillator output may be independently programmed for ФB
and ФC. The ФA output is always defined as the 0° reference. The phase relationship between the three
output vectors can be controlled from 0° to 359° in 1° increments.
Range:
0 - 359 °
Resolution:
± 1°
Accuracy:
± 0.5°
2.1.8 WAVEFORM SYNTHESIS SPECIFICATIONS
(Option: Harmonic Analysis and Synthesis)
HARMONIC RANGE: 2 through 51.
MAGNITUDE: Percentage, referenced to the fundamental (always defined as 100%).
Range:
0% to 999%
Resolution:
0.1%
Accuracy:
± 1% referenced to the fundamental
PHASE ANGLE: Based on a Sine series.
Range:
0° to 359.9°
Resolution:
0.1°
Accuracy:
± 2% F.S.
CALCULATION TIME to create a waveform: approx. 3 seconds +1 second for each non-zero magnitude.
NOTE: The waveform is synthesized using a sine series with coefficients expressed in polar format
(magnitude and phase angle).