Pacific Power Source UPC-32 - Event and Status Reporting; IEEE-488.2 Status Reporting

SECTION 5 REMOTE OPERATION
71
5.3.1 STEADY-STATE OUTPUT PARAMETERS
FORM,<n>
sets Output Power Form of selected program
n = <1>Single Ф, <2>Split Ф, or <3>Three Ф
COUPLing,<s>
sets Output coupling of selected program
s = <DIRECT> or <XFMR>
XFMRRATIO,<n.nn>
sets Output XFMR ratio (n.nn:1) of selected program
n.nn = <0.01> to <5.11>
FREQuency,<n>
sets Output Frequency of selected program
n = <:SOUR:FREQ:LIM:MIN> to <:SOUR:FREQ:LIM:MAX> Hz
VOLTage,<n>
sets Output VOLTAGE ФA,B,C of selected program
n = <0> to <150, or 150 x XFMRRATIO> Volts
VOLTage1,<n>
sets Output VOLTAGE ФA of selected program
n = <0> to <150, or 150 x XFMRRATIO> Volts
VOLTage2,<n>
sets Output VOLTAGE ФB of selected program
n = <0> to <150, or 150 x XFMRRATIO> Volts
VOLTage3,<n>
sets Output VOLTAGE ФC of selected program
n = <0> to <150, or 150 x XFMRRATIO> Volts
CURRent:LIMit,<n>
sets Output Current Limit of selected program
n = <0> to <AMPS meter range> Amps
CURRent:PROTect:LEVel,<n>
sets Output Current level that triggers Current Protect mode
n = <0> to <AMPS meter range> Amps
CURRent:PROTect:TOUT,<n>
sets time that the Output Current must exceed the Current Protect
level before Current Protect disables the power source output.
n = <1> to <65535>, 1 = 100mSec.
PHASe2,<n>
sets Output Phase Angle B of selected program
n = <0> to <359> degrees
PHASe3,<n>
sets Output Phase Angle C of selected program
n = <0> to <359> degrees
WAVEFORM,<n>
sets Output Waveform ФA, ФB, ФC of selected program
n = <1> to <16>
WAVEFORM1,<n>
sets Output Waveform ФA of selected program
n = <1> to <16>
WAVEFORM2,<n>
sets Output Waveform ФB of selected program
n = <1> to <16>
WAVEFORM3,<n>
sets Output Waveform ФC of selected program
n = <1> to <16>