Pacific Power Source UPC-32 - Section 3: Installation Procedures; Remove Input Service; Remove Cover and Cabling; Remove Existing Controller

SECTION 3 INSTALLATION
20
SECTION 3
INSTALLATION
3 INSTALLATION
This section describes installation of an UPC into a SCU.
NOTE: It is recommended that the user return the product to the factory if a controller or power source
upgrade is desired, however, the following installation information is provided for reference. Refer to the
power source manual for installation into a Pacific Power Source, Inc. power source system. Should any
question arise, call Pacific Power Source, toll free, at 1-800-854-2433.
WARNING
THIS EQUIPMENT CONTAINS HIGH ENERGY, LOW IMPEDANCE CIRCUITS!!
LETHAL POTENTIALS ARE CONTAINED WITHIN THE CABINET.
DO NOT REMOVE ANY PANELS OR COVERS WITHOUT FIRST REMOVING
THE INPUT SERVICE POWER AND OPENING ALL CIRCUIT BREAKERS.
CAUTION
Read Section 3, INSTALLATION, before installing or operating this equipment.
Installation of an UPC into a SCU consists of the following steps:
STEP
DESCRIPTION
REFERENCE
1
Open all Circuit Breakers and remove Input Service
(3.1)
2
Remove cover and cabling
(3.2)
3
Remove existing controller
(3.3)
4
Configure UPC
(3.4)
5
Install UPC
(3.5)
6
Install cabling and cover
(3.6)
7
Connect Input Service and power on
(3.7)