Pacific Power Source UPC-32 - Page 6

ii
TABLE OF CONTENTS
PAGE
3 INSTALLATION .................................................. 20
3.1 REMOVE INPUT SERVICE ...................................... 21
3.2 REMOVE COVER AND CABLING ................................. 21
3.3 REMOVE EXISTING CONTROLLER ............................... 21
3.4 CONFIGURE UPC ............................................. 21
3.4.1 CONFIGURE TRANSFORMER RATIO ........................... 21
3.4.2 CONFIGURE AMPS TO VOLTS RATIO .......................... 22
3.4.3 CONFIGURE GPIB DEVICE ADDRESS .......................... 23
3.4.4 CONFIGURE MISCELLANEOUS SETTINGS ...................... 23
3.5 INSTALL UPC ................................................ 25
3.6 INSTALL CABLING AND COVER ................................. 25
3.7 CONNECT INPUT SERVICE ..................................... 25
4 FRONT PANEL OPERATION ........................................ 27
4.1 GUIDE TO OPERATION ........................................ 27
4.1.1 OVERVIEW ............................................... 27
4.1.2 BASIC OPERATION ........................................ 29
4.2 FRONT PANEL CONTROLS AND INDICATORS ...................... 31
4.2.1 POWER SOURCE FRONT PANEL .............................. 31
4.2.2 UPC FRONT PANEL ........................................ 32
4.3 MANUAL MODE .............................................. 33
4.3.1 METERING DISPLAYS ...................................... 33
4.3.2 VOLTAGE ENTRY .......................................... 36
4.3.3 FREQUENCY CONTROL ..................................... 36
4.4 PROGRAM OPERATE MODE .................................... 36
4.4.1 PROGRAM EXECUTION ..................................... 37
4.4.2 TRANSIENT EXECUTION .................................... 37
4.5 PROGRAM EDIT MODE......................................... 40
4.5.1 PROGRAM EDITING ........................................ 40
4.5.2 TRANSIENT EDITING ....................................... 44
4.6 SETUP MODE ................................................ 53
4.6.1 PROGRAM SETUP ......................................... 53
4.6.2 WAVEFORM SETUP ........................................ 55
4.6.3 GENERAL SETUP .......................................... 59