Palm 600 - Connecting Treo to Your Computer

20
Connecting
2
Connecting Treo to Your Computer
IMPORTANT: If you’re upgrading from another Palm Powered device, follow the upgrade steps
on page page 149 before you set up your computer for your new Treo.
1. Plug the AC charger into a wall outlet. If necessary, connect an adapter.
2. Connect the charger to the short end of the HotSync cable. Be sure to match
the sides of the connectors labeled UP.
3. Plug the USB HotSync cable into an available USB port or a powered USB hub
on your computer.
4. Connect the long end of the HotSync cable to the bottom of your Treo with
the button facing up. Do not press the HotSync button until you are instructed
to do so in the next step.
USB Cable
Start Here.book Page 20 Monday, September 8, 2003 11:13 AM