DBS
FF-B LCR mod ,,d
&
\ -Y
FFB-3#-(l- 4)#- (000 - 999 or[CONFl)#
Special area code table storing
In order to find the cheapest outside line group to
be used from among the numbers stating with 6
digits when making an LCR call, the
call
is made in
accordance with the special office code for each
special area code specified by the time priority
table.
Rather than the area code or office code being
determined individually, a telephone number of 6
digits combining the special
area code and
special
office code is stored.
In this table are stored 4 special area code (000 -
999) tables, and special area codes already stored
are deleted by inputting [CONF].
The dial decided on
forthe
special area code for
NPX as shown below.
(N = 2-9,P = 0-1.X = O-9)
1 + Area code : I-w-Xxx-xXxX
NON 1 + Areacode: m-XXX-XXXX
Special area codes not stored in thistable cannot
be used for LCR calls. The structure forthe data
-.
storing in the tabie is as follows.
-.
SECTION 400 (Version 3.0)
Issue 1 January 1990
Special Area code Table Number I #
Special
area
code DATA:
(000-999)# or Delete:(CONF]
Special Area code Table Number 2#
Special area code DATA:
(OOO-999)# or Delete:[CONFI
Special Area code Table Number 38
Special area code DATA:
(OOO-999)# or Delete:[CONFj
Special Area code Table Number 4#
Special area code DATA:
(OOO-999)# or Delete:[CONFl
NOTE 1: For the system installation area it is
necessary to set either 1 + Area or
Non 1 + Area.
NOTEZ: LCR calls cannot be made from outside
lines connected to a PBX.
-68-
To Next Page
Loading...
