S-DBS Operating Instructions
Section 700
Vl .o
issue 1 July 1990
You can set a system alert tone to signal you when a line becomes free ifall the outside
lines or bxnk goups are busy.
To set Trunk Queuing
1.
Press
ON/OFF
key
2.
Press busy line key
3. Dial 2
4.
When you hear a continuous dial tone the Iine is set for an alert tone.
To respond to a ‘hunk Queuing alert tone
1.
Pick up the receiverwithin 16 seconds or Punk Queuing is cancelled.
___...-._ -.--. ~_ ._,... _~ ._.
2.
Listen for the outside dial tone
3. Begin dialing
NOTE: If an incoming call rings
on the line key set for Trunk Queuing it is
suspended for the duration of the incoming calI. It is also cancelled after
20 minutes if not used within that time.
This feature is also available
on an
SLT.
26
To Next Page
Loading...
