S-DBS Operating Instructions
VI .o .I ,
Section 700
Issue 1 July 1990
HOLDING CALLS
Outside Line Hold
There are two methods of placing an outside caller on hold.
Exclusive hold restricts
the release of a hold only to the extension that put the call on hold.
System hold is
not restricted and the call can be picked up at any extension.
To place a call on Exclusive Hold
1.
Press the green line key, it will flash ranidlv and you will hear a con-
tinuous tone.
2. Press ON/OFF
key
OR
Replace the receiver
To release a call from Exclusive Hold
1.
Press the rapidlv flashing green LED line key, it will stop flashing and
blink green.
To place a call on System Hold
Not restricted - any extension can release a system hold.
1.
Press HOLD
key. The green LED line will flash ranidlv and you will
hear a continuous dial tone.
2. Press ON/OFF
key.
OR ~
Replace the receiver
To release a call from System Hold
1.
Press the raDidlv flashing LED line, it will blink green.
NOTE:
If a call on hold is not answered within a specific time, a hold recall tone will
sound.
cProgramming Required>
18
To Next Page
Loading...
