Panasonic 616 - To Release a Call on Hold; Call Waiting * <Programming Required; To Set Call Waiting; To Answer Call Waiting During an Outside Line;Internal Call

Section 700
S-DBS Operating Instructions
Issue 1 July 1990
Vl .o
To release a call on Hold
1. Press HOLD key.
2.
The EXT LED will stop flashing.
NOTE: There is no Hold recall for Intercom Hold.
Call Waiting l cprogrcUnming Required>
To set Call Waiting
1. Press ON/OFF key
2. Dial the extension number and wait for the busy signal.
3. To send the Call-Wait tone to the extension, press 3 while you
can still hear the busy signal. The EXT LED of the called party will
flash red.
To answer Call Waiting during an outside line/internal call
1. Press HOLD key
2. The first call is held and you are automatically connected to the
waiting caller. The new extension number will appear on the display.
NOTE: Call Waiting is automatically canceled once you replace the receiver. This
feature is not active ifthe called extension is set to DND; already has a call
on hold; is ringing or is on a conference call. An alert tone will signal that
Call Waiting is not in effect.