Panasonic 616 - Page 2

Section 300
Issue 1 August 1990
a+
S-DBS Installation Instructions
Vl .o
FCC RULES AND REGULATIONS (Part 68)
In compliance with the requirements of Part 68 of the FCC Rules and Regulations for
connection of terminal equipment to the telephone network, and for your convenience,
the following information is presented.
Notifying the Telephone Company
When connecting or disconnecting the terminal equipment to the telephone network
inform the telephone company of the particular line (s) for connection,“the FCC
registration number and ringer equivalence number of the registered terminal
equipment.
FCC RegMration Numb&s
Model Numbers
Key System
Hybrid System
VB-42010 (DBS308)
ACKUSA-61853~KF-E ACKUSA-61855-m-E
VB-42020 (DBSSlS)
ACKUSA-61854KF-E ACKUSA-61856-Ml?-E
When enabling Pooled Trunk Access, inform the telephone company or a Panasonic
service center of the MF-E FCC Registration number. According to FCC rules, Pooled
Trunk Access is regarded as one of the distinguishing features of a Pl3X as opposed
to a key telephone system.
RINGER EQUIVALENCE NUMBER @ZEN)
0.5j B
The REN determines the number of devices you may connect to your telephone line
and still have all those devices ring when your telephone number is called.
In most,
but not all areas, the sum of the REIVs of all devices connected to one line should not
exceed five (5.0). You should contact your local telephone company to determine the
maximum REN for your calling area.
Service order code
9.OF
Network address signaling code
E
Facility interface code
02LS2 (2 wire/Loop start)
Required network interface code
RJ25C
Connection to a Party Line or Coin Operated Telephone Line
*
Direct Connection to a Party Line or Coin Operated Telephone Line Is Prohibited.
If you are on a party line, check with your local telephone company for further
information.