Section 400
Issue 1 July 1990
S-DBS Programming Instxuc~ln~
.
-
-___--
INITIALKXNG THE SYSTEM BEFORE PROGRAMMING
Before programmin
g for the first time, reset the system as follows:
1. Turn off the power for the Main Cabinet.
2. Set the RAlld switch to 9XZAR”.
3. Turn the power for the Main Cabinet back on.
4. Set the
RAM
switch to
“HOLD”.
a
NOTE: This is a one-time operation. If the procedure
is repeated at the next programming session, aJl
previously programmed data will be erased.
.
3
To Next Page
Loading...
