Section 400
Issue
1 July 1990
S-DBS Programming Instructions
v1.0
OOOS#-(l-S)#
AUTOBBATICPAUSE-DIAL1
Automatically inserts a pause during dialing. When accessing a CO line through a
PBX, it can take several seconds from the time the Iine is accessed to when it
connects with a CO (outside) line.
. . .
COIW No automatic na se afte d ahng d pit
1
1 #: .Automatic pause .be&e the ‘1 si digit &er dialing
1
2#: Automatic pause before the
2nd
digit after dialing 1
3#: Automatic pause before the 3rd digit after dialing 1
4#: Automatic pause before the 4th digit after dialing 1
5#: Automatic pause before the 5th digit after dialing 1’
6#: Automatic pause before the 6th digit after dialing 1
7#: Automatic pause before the 7th digit after dialing 1
8#: Automatic pause before the 8th digit after diaIi.ng 1
Numbers dialed before the connection is made result in a wrong number.
‘:This setting also affects dialing SSD and PSD numbers.
Pause time is set with the Automatic Pause Timer at:
0016#-(0,1-7)#
NOTE:
Each trunk must be set for automatic pause in
PSD 2
as follows:
PSD 2 Key,Address (Ol-06)~04#-(0 or l)#
OOO?#-(I-8)#
AUTOMATICPAUSE-DIAL2
CONF: No automatic cause after dialing di
l#: Automatic pause before the 1st digit a
2#: Automatic pause before the
2nd digit
a
3% Automatic pause before the 3rd digit a
4ff; Automatic pause before the 4th digit a
5#: Automatic pause before the 5th digit a
6#: Automatic pause before the 6th digit a
7#: Automatic pause before the 7th digit a
8#: Automatic pause before the 8th digit a
gi&&
$er d&kg 2
ter dialing 2
hrdialiIlg2
ker dialing 2
z&di.g 2
ker diaIing 2
Iter diaIi.ng 2
ker dialing 2
23
To Next Page