Panasonic AG-CX350

– 100 –
Chapter 4 Operation — Menu settings
- [1280×720-60fps 14M], [1280×720-60fps 10M], [1280×720-60fps 6M]
(Factory setting: [1280×720-60fps 10M])
@@
NOTE
t Cannot be set when [FILE FORMAT] is set to [AVCHD] or [REC FORMAT] is set to UHD or 1080/23.98p.
[MULTICAST]
Enables/disables the multicast function.
(Factory setting: [DISABLE])
[MULTICAST ADDRESS]
Sets the address when using the streaming with the multicast.
(Factory setting: [239.192.0.20])
[MULTICAST PORT]
Sets the port number when using the streaming with the multicast.
(Factory setting: [37004])
[CLEAR ACTIVATION]
Clears the activation license information that is saved.
The items that can be selected are as follows.
f [YES], [NO]
[LAN PROPERTY]
Performs settings related to the wired LAN.
[MAC ADDRESS]
Displays the MAC address for the wired LAN of the camera. (Cannot be changed)
[IPv4 SETTING]
[DHCP] Sets whether to use the automatic acquisition through DHCP or to use the DHCP server function of the camera.
[OFF]: Does not use DHCP.
[CLIENT]: Acquires automatically with DHCP.
The address from 192.168.0.10 through 192.168.0.255 is automatically assigned when the IP address cannot be acquired
automatically within one minute.
[SERVER]: Enables the DHCP server function of the camera.
f Factory setting: [OFF]
[IP ADDRESS]
Sets the IP address.
f Factory setting: [192.168.0.1]
@@
NOTE
t Cannot be set when [LAN PROPERTY] → [IPv4 SETTING] → [DHCP] → [CLIENT] is selected.
[SUBNET MASK] Sets the subnet mask.
f Factory setting: [255.255.255.0]
@@
NOTE
t Cannot be set when [LAN PROPERTY] → [IPv4 SETTING] → [DHCP] → [CLIENT] is selected.
[DEFAULT GATEWAY] Sets the default gateway.
f Factory setting: [192.168.0.254]
@@
NOTE
t Cannot be set when [LAN PROPERTY] → [IPv4 SETTING] → [DHCP] → [CLIENT] is selected.
[PRIMARY DNS] Sets the primary DNS server.
f Factory setting: [0.0.0.0]
[SECONDARY DNS] Sets the secondary DNS server.
f Factory setting: [0.0.0.0]
[IPv6 SETTING]
[ENABLE/DISABLE] Sets whether to use IPv6.
[ENABLE]: Uses IPv6.
[DISABLE]: Does not use IPv6.
f Factory setting: [DISABLE]
[DHCP] Sets whether to use automatic acquisition via DHCP.
[OFF]: Does not use DHCP.
[CLIENT]: Performs automatic acquisition through DHCP.
f Factory setting: [OFF]
[IP ADDRESS] Sets the IP address.
f Factory setting: [::]
[PREFIX LENGTH] Sets the prex length of the subnet.
f Factory setting: [64]
[DEFAULT GATEWAY] Sets the default gateway.
f Factory setting: [::]