– 203 –
Chapter 10 Notes — Warning system
Screen display
Description Behavior and cause
Camera image screen
[Exceeds capacity. Please reselect.] The remaining recording capacity of the memory card for
the copy destination is insufcient.
A message is displayed.
f Select the clip to copy again, or secure enough space in
the remaining recording capacity on the memory card for
the copy destination.
[Check the destination media.] An error has occurred on the memory card for the copy
destination while copying.
A message is displayed.
f Conrm the memory card for the copy destination.
[LOAD NG] Loading of the scene le has failed. A message is displayed.
f Check the memory card.
[SAVE NG] Writing of the scene le has failed. A message is displayed.
f Check the memory card.
[DISCONNECT USB CABLE.] Due to an OS non-compatible error, ve minutes has
elapsed until the service mode connection is established.
A message is displayed.
f Conrm if the OS in use is supported by the camera.
[CARD LOCKED.] The camera tried to protect or delete a clip on a memory
card that has been locked.
The camera tried to copy a clip to the memory card that
has been locked.
A message is displayed.
f Unlock the memory card.
[CANNOT SELECT MORE CLIPS.] It has tried to select more than 99 clips. A message is displayed.
f Execute the process such as copying by every 99 clips.
[SELECT THE CLIP TO BE
DELETED.]
It has tried to delete a clip without choosing any. A message is displayed.
f Select a clip to be deleted.
[SELECT THE CLIPS TO COPY.] It has tried to copy a clip without choosing any. A message is displayed.
f Select a clip to be copied.
[SELECT THE CLIP TO RE‑
CONNECT.]
It has tried to re-connect without choosing any clip. A message is displayed.
f Select the clip to be re-connected.
[NO CARD.] Copying was tried to be executed without inserting a
memory card into the card slot.
A message is displayed.
f Insert a memory card into the card slot.
[REINSERT OR CHECK CARD
<SLOT 1>]/[REINSERT OR CHECK
CARD <SLOT 2>]
It has tried to copy to an error card. A message is displayed.
f Check the memory card.
[CANNOT COPY.] Copying was attempted while the system frequency
(59.94 Hz and 50.00 Hz) of the memory card to copy from
and the memory card to copy to are different for content
recorded in AVCHD format.
A message is displayed.
f Set the same system frequency (59.94 Hz system or
50.00 Hz system) for the content of the memory card to
copy from and the memory card to copy to.
f The system frequency information for the AVCHD format
is conrmed at the time of formatting or at the rst
recording.
[CANNOT RECORD.] Cannot be recorded. A message is displayed.
f Perform recording after making it possible.
[REC PAUSE INVALID] The camera tried to stop the next recording before the
previous recording nished writing to the memory card.
A message is displayed.
f Stop recording after writing to the memory card is
complete. Recording can be stopped after the message
that is displayed disappears.
[WRITE PROTECTED] The memory card has been write-protected. A message is displayed.
f Insert a memory card with write access.
To Next Page
Loading...
