– 46 –
Chapter 3 Preparation — Preparing the memory card
B002
PRIVATE
CONTENTS
LASTCLIP.TXT
AVCLIP
AUDIO
CLIP
PANA_GRP
001RCQAM
002YCJAM
BACKUP.TMP
INDEX.DAT
AVCHD
AVCHDTN
BDMV
PANA_EXT
1
8
9
10
11
2
4
3
7
12
13
14
ICON
5
6
PROXY
VIDEO
VOICE
P2 format
MOV format
AVCHD format
1 Volume label of the memory card
2 Video data in MXF format (audio: LPCM) (when recording format is AVC-Intra 422/AVC-LongG50/AVC-LongG25/AVC-LongG12)
3 Audio data in MXF format (when recording format is AVC-Intra 200/AVC-Intra 100/AVC-Intra 50)
4 Meta data in XML format
5 Thumbnail in BMP format
6 Video data in MXF format (when recording format is AVC-Intra 200/AVC-Intra 100/AVC-Intra 50)
7 The le to which the information of the nal clip was recorded
8 Video data in MOV format: UHD (3840×2160), 29.97P MOV (audio: LPCM)
9 Video data in MOV format: FHD (1920×1080), 59.94i MOV (audio: LPCM)
10 Management le 1
11 Management le 2
12 Thumbnail of video data
13 Video data in AVCHD standard (00000.MTS, etc.)
14 Management folder
@@
NOTE
t Do not erase a folder or le on the memory card with a computer. It may make it impossible to load on the camera.
t If data is recorded to the memory card with a computer, an error may occur such as an inability to recognize or record to the memory card with the
camera.
t The memory card to use with the camera should always be formatted on the camera.
t The number of the P2 format clips that can be recorded on a single memory card is approximately 1000, and the AVCHD format clips is approximately
3900.
Data will not be able to record when it reaches the maximum number of data that can be recorded.
t When transferring a recording data in a P2 format to a computer, or when writing back to a microP2 card, be sure to use the dedicated software “P2
Viewer Plus” to prevent data loss. For details on downloading P2 Viewer Plus and the operating environment, visit the support desk at the following
website:
https://pro-av.panasonic.net/
t Follow the instructions below when using a general IT tool such as the OS standard le manager equipped on a computer to transfer a recording data
in P2 format to a computer. However, be sure to use P2 Viewer Plus when returning data back to a microP2 card.
‑ Perform the transfer for each CONTENTS folder and LASTCLIP.TXT le.
‑ Do not operate the folders under the CONTENTS folder.
‑ When copying, copy the LASTCLIP.TXT le at the same time as the CONTENTS folder.
‑ When transferring the data in multiple microP2 cards to a computer, create a folder for each memory card to prevent clips with the same name from
being overwritten.
To Next Page
Loading...
