Panasonic AG-CX350

– 73 –
Chapter 4 Operation — Menu settings
The items that can be set are as follows.
f When [SYNC SCAN TYPE] is set to [sec] and the [SYSTEM] menu → [FREQUENCY] → [59.94Hz] is set
- 59.94i/59.94p mode: [1/60.0] … [1/7200]
- 29.97p mode: [1/30.0]…[1/7200]
- 23.98p mode: [1/24.0]…[1/7200]
f When [SYNC SCAN TYPE] is set to [sec] and the [SYSTEM] menu → [FREQUENCY] → [50.00Hz] is set
- 50i/50p mode: [1/50.0]…[1/7200]
- 25p mode: [1/25.0]…[1/7200]
f When [SYNC SCAN TYPE] is set to [deg]
- [3.0d]…[360.0d]
[MASTER DTL]
Sets the level of the detail effect of the whole part.
The items that can be set are as follows.
f [−31]…[31]
@@
NOTE
t This cannot be set when the [SYSTEM] menu → [COLOR SETTING] is set to [V-Log].
[DTL CORING]
Sets the level of signal (including noise) that does not activate the detail effect.
The items that can be set are as follows.
f [0]…[60]
@@
NOTE
t This cannot be set when the [SYSTEM] menu → [COLOR SETTING] is set to [V-Log].
[DETAIL SETTING]
This cannot be set when the [SYSTEM] menu → [COLOR SETTING] is set to [V-Log].
[DETAIL]
Sets [ON]/[OFF] of the detail function.
The items that can be set are as follows.
f [ON], [OFF]
[V.DTL LEVEL]
Sets the intensity of the detail level in the vertical direction.
The items that can be set are as follows.
f [−7]…[7]
[DTL FREQ.]
Sets the thickness of the detail.
The items that can be set are as follows.
f [−7]…[7]
[LEVEL DEPEND.]
When the detail of luminosity signal is emphasized, details in the darker areas are compressed.
Details of bright areas are compressed more when the value set for [LEVEL DEPEND.] is larger.
The items that can be set are as follows.
f [−7]…[7]
[KNEE APE LVL]
Sets the detail level of high luminosity areas (high-brightness areas).
The items that can be set are as follows.
f [0]…[5]
[DTL GAIN(+)]
Sets the detail level of the plus direction (to make brighter).
The items that can be set are as follows.
f [−31]…[31]
[DTL GAIN(−)]
Sets the detail level of the minus direction (to make darker).
The items that can be set are as follows.
f [−31]…[31]
[SKIN TONE DTL A]
Selects the skin tone table that will display the skin tone detail.
Create the skin tone table with [DETECT TABLE]. You can shoot smoother skin tones by displaying the skin tone detail.