Panasonic AG-CX350

– 93 –
Chapter 4 Operation — Menu settings
[HOLD] Enables the enlarged display function until the <FOCUS ASSIST> button assigned to [EXPAND] or the USER button is
pressed or the USER button icon is touched again.
[UNTIL REC] Enables the enlarged display function until performing recording operation.
(Factory setting: [10SEC])
[EXPAND VALUE]
Adjusts the enlargement factor of the enlarged display function.
The items that can be set are as follows.
f [×2], [×3], [×4]
(Factory setting: [×2])
[PEAKING LEVEL]
Sets the intensity of the peaking display.
The items that can be set are as follows.
f [LOW], [MID], [HIGH]
(Factory setting: [MID])
[PEAKING COLOR]
Sets the color of the peaking display.
The items that can be set are as follows.
f [RED], [GREEN], [WHITE]
(Factory setting: [RED])
[BLACK & WHITE]
Enables/disables the monochrome display.
[ON] Enables the monochrome display.
[OFF] Disables the monochrome display.
[DURING PEAKING] Enables the monochrome display while the peaking display is enabled.
(Factory setting: [OFF])
[DETAIL]
Sets the intensity of the contour for the video to make it easier to focus.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [ON])
[DETAIL LEVEL]
Sets the intensity of the contours.
The items that can be set are as follows.
f [−3]…[3]
(Factory setting: [0])
[DETAIL FREQ.]
Adjusts the frequency of the contour highlights.
The items that can be set are as follows.
f [HIGH], [LOW]
(Factory setting: [LOW])
[EI ASSIST]
[ZEBRA]
Sets whether to superimpose the zebra signal to the output.
[MOMENT] Press the USER button to which [ZEBRA] is assigned or touch the USER button icon to superimpose the zebra signal for
approximately ve seconds.
[ON] Always superimposes the zebra signal. Press the USER button to which [ZEBRA] is assigned in the [ON] settings or touch
the USER button icon to set to [OFF].
[OFF] Does not superimpose the zebra signal. Press the USER button to which [ZEBRA] is assigned in the [OFF] settings or touch
the USER button icon to set to [ON].
(Factory setting: [OFF])
@@
NOTE
t The setting is xed to [OFF] when the [SYSTEM] menu → [COLOR SETTING] is set to [V-Log].
[ZEBRA1 DETECT]
Sets the detection level of zebra pattern 1.
The items that can be set are as follows.
f [0%]…[109%]
(Factory setting: [80%])