- 119 -
Setting the external output resolution
Change the setting for outputting images to an external monitor or other external device (recorder,
etc.).
Select the menu.
≥ [SYSTEM] automatically sets the output resolution according to the setting in [REC FORMAT].
If the images are not output on the external device when the setting is [SYSTEM], switch to the
method [1080p], [1080i] or [DOWN CONV.] which enables the images to be displayed on your
external device. (Please read the operating instructions for the external device.)
≥ [DOWN CONV.] outputs images in standard picture quality.
∫ To use an AV cable for external output
1 Select the [AV OUT] menu.
2 Select the [RESOLUTION] menu.
≥ In the following cases, the video and audio are not output from VIDEO OUT terminal and AUDIO
OUT terminal:
j When an HDMI cable is connected to this unit
j [RESOLUTION] is set to the settings other than [DOWN CONV.] (Unless [REC FORMAT] is set
to [SA 576/50.00i])
≥ When [REC FORMAT] is set to [SA 576/50.00i], [RESOLUTION] is fixed to [SYSTEM].
≥ [RESOLUTION] cannot be set during Freeze Frame. (l 86)
≥ Images may not be displayed on the external device for several seconds in some cases, such as
when changing between scenes.
The external output resolution varies depending on the [RESOLUTION] setting and connected
terminal.
≥ When [RESOLUTION] is set to [SYSTEM], the external output resolution varies depending on the
picture size and frame rate in [REC FORMAT].
: [OUTPUT SETUP] # [RESOLUTION] # desired setting
[SYSTEM]/[1080p]/[1080i]/[DOWN CONV.]
: [DISP SETUP] # [AV OUT] # [ON]
: [OUTPUT SETUP] # [RESOLUTION] # [DOWN CONV.]
About external output resolutions
MENU
AG-UX90EJ_DVQP1150ZA.book 119 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
