EasyManua.ls Logo

Panasonic AlCare TK-AS500 - Odor, taste, and color issues

Panasonic AlCare TK-AS500
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Check point
Drain hose
Water is drained
even after the faucet
is closed
z Water inside the main unit is drained every after use.
(P. EN27, EN31)
Water is not drained
while alkaline ion
water or acidic water
is used
z Is the drain hose bent or attened?
Running water continuously may cause malfunction. Also the
water cannot be electrolyzed correctly.
Sound and buzzer
A buzzer does not
beep while acidic
water is used
z Has the buzzer been muted? (P. EN32)
Odor, taste, turbidness, and change in color
The water produced by
the Alkaline Ionizer has
an odor or unpleasant
taste or is turbid
z Purication performance of the cartridge is deteriorated.
Replace the cartridge. (P. EN30)
z
If an odor occurs within 2 to 3 months after the cartridge is replaced,
the water discharge line or waste water line may be soiled.
Press the Acidic Water button, and run acidic water for approx. 15
seconds.
The smell at the
beginning of use of
water concerns me
z
Since water is accumulated inside the main unit for 10 minutes after
Alkaline 1 to 3 and Puried are used, there are rare cases where
some people are sensitive to the smell of the main unit.
If the smell concerns you, after a buzzer beeps, run water for a while
before using.
The acidic water has
an odor
z Electrolysis causes the chlorine ions in the water to collect in
acidic water, forming hypochlorous acid.
There is no problem if you use it as is.
White oating matter
is mixed with the
alkaline ion water
z White oating matter is calcium deposited inside the main unit.
z Foam-like oating matter is the air inside the main unit or
hydrogen foam generated during electrolysis.
(There is no problem if you use it as is.)
This foam tends to be much generated after installation or
cartridge replacement.
In the case of acidic water, oxygen foam is generated.
Alkaline ion water or
puried water looks
shiny
z This occurs when components (mainly minerals) dissolved in the
water oat.
There is no problem if you use it as is. But if it bothers you, use
alkaline ion water at a lower pH level.
EN41
When necessary
English

Related product manuals