VQT2N02 21
For details about the setting procedure in the [SETUP] menu. (→14)
[VIDEO OUT]
Change the video output
format when connected
to a TV, etc. (Playback
mode only).
[NTSC]/[PAL]
• Operates when AV cable is connected.
[TV ASPECT]
Change the aspect ratio
when connected to a
TV, etc. (Playback mode
only).
/
• Operates when AV cable is connected.
[VERSION DISP.]
Check the version of the
camera firmware.
Current version is displayed.
[FORMAT]
Use when [BUILT-IN
MEMORY ERROR]
or [MEMORY CARD
ERROR] appears, or
when formatting the built-
in memory or card.
When a card/built-in
memory is formatted,
the data cannot be
restored. Check the
content of the card/
built-in memory
carefully before
formatting.
[YES]/[NO]
• This requires a sufficiently charged battery (→8) or AC
adaptor (optional). When formatting the built-in memory,
remove the cards.
(Only inserted card will be formatted if present; built-in
memory will be formatted if no card is inserted.)
• Always format cards with this camera.
• All picture data including protected pictures will be
deleted. (→72)
• Do not turn off power or perform other operations during
formatting.
• Formatting the built-in memory may take several
minutes.
• Consult your nearest Service Centre if format cannot be
successfully completed.
Item Settings, notes
To Next Page
Loading...
