Panasonic DMC-FP2 - Using with Your PC

74 VQT2N02
Using with your PC
■
To cancel connection
Click ‘Safely Remove Hardware’ in the Windows System Tray → disconnect USB
connection cable → turn off camera power → disconnect AC adaptor
Turn on power of both
camera and computer
Connect camera to
computer
• Please make sure you use the
supplied USB connection cable.
Use of cables other than the
supplied USB connection cable
may cause malfunction.
Select [PC] on the camera
A message may be displayed on screen
if [USB MODE] (→20) is set to [PictBridge
(PTP)]. Select [CANCEL] to close the
screen, and set [USB MODE] to [PC].
Operate with your computer
Check socket direction and insert straight in.
(Damage to socket shape can lead to faulty
operation.)
[ACCESS] (sending data)
• Do not disconnect the
USB connection cable
while [ACCESS] is
displayed.
USB connection cable
(always use cable
supplied)
If using AC adaptor,
turn off the camera
before plugging in or
removing.
Hold here
(Push until it is fully
inserted.)
Pictures and motion pictures can be imported from the camera to your computer by
connecting the two together.
• If your computer does not support SDXC memory cards, a message will be displayed
requesting you to format the card. (Do not format the card. This will erase recorded
pictures.) If the card is not recognized, refer to the following support website:
http://panasonic.net/avc/sdcard/information/SDXC.html
• Imported pictures can then be printed or sent by e-mail using the ‘PHOTOfunSTUDIO’
software on the CD-ROM (supplied).
Getting Ready:
• Use a fully charged battery or connect an AC adaptor (optional).
• When importing pictures from the built-in memory, remove any memory cards.