VQT2N02 51
Useful features for travel
Recording mode:
∗
∗
Recording only. (Cannot set.)
[TRAVEL DATE] (Record travel date and destination)
Record information as to what day and where pictures were taken by setting departure
dates and destinations.
Set-up: • Clock must be set in advance (→12).
• Press [MENU/SET] → [SETUP] menu → Select [TRAVEL DATE]
●
The number of days elapsed is displayed for approx. 5 sec. when switching from Playback
to recording mode or when power is turned on. ( displayed at bottom-right of screen)
●
When destination is set in [WORLD TIME] (→52), days elapsed are calculated based on
local destination time.
●
If settings are made before departure date, number of days to departure are displayed
in orange with a minus sign (but not recorded).
●
When [TRAVEL DATE] is displayed in white with a minus sign, the [HOME] date is one
day in advance of the [DESTINATION] date (this is recorded).
●
To print travel date or destination → Use [TEXT STAMP], or print using supplied
CD-ROM ‘PHOTOfunSTUDIO’.
●
[TRAVEL SETUP] can be recorded during motion picture recording, but [LOCATION] cannot.
Select [TRAVEL SETUP]
Select [SET]
Set departure date
Press ▲▼◄► to set the return
date, and then press [MENU/SET]
To continue without setting the return
date, press [MENU/SET] without
entering anything.
Select [LOCATION]
Select [SET]
Enter destination
• ‘Entering Text’ (→60)
• Press [MENU/SET] twice after inputting
text to complete.
■
Clearing the information
After the return date, the information
is automatically cleared. To clear the
information before this date, select [OFF]
in step
, and then press [MENU/SET]
3 times to close the menu.
To Next Page
Loading...
