Panasonic DMC-FP2 - Page 36

36 VQT2N02
Taking pictures with flash (Continued)
Recording mode:
■
Available types in each mode (○: Available, —: Not available,
○
: Default setting)
[SCENE MODE]
○○
∗
○○○○○ - ○ -- ○○○ -- ○○○
○ - ○○○○ ----- ○ ------ ○
○ - ○○○○○ - ○ -- ○○○○○○○○
--------- ○○ --------
------- ○ - ○○ --------
○○○○○○○○○○○○○○ - ○○○○
∗
Set to (Auto), (Auto/Red-Eye Reduction), (Slow Sync./Red-Eye Reduction) or
(Slow Sync.) according to the subject and brightness.
• The flash cannot be used in Motion Picture Mode and in these Scene Modes: , ,
, , , and .
■
Focus range according to ISO Sensitivity and zoom
Focus range
Max. W Max. T
[SENSITIVITY]
(→54)
[
]
Approx. 0.3 m - 4.9 m
(0.99 feet - 16.08 feet)
Approx. 0.5 m - 2.9 m
(1.64 feet - 9.51 feet)
ISO80 Approx. 0.3 m - 1.0 m
(0.99 feet - 3.28 feet)
Approx. 0.5 m - 0.6 m
(1.64 feet - 1.97 feet)
ISO100 Approx. 0.3 m - 1.2 m
(0.99 feet - 3.94 feet)
Approx. 0.5 m - 0.7 m
(1.64 feet - 2.29 feet)
ISO200 Approx. 0.4 m - 1.7 m
(1.32 feet - 5.58 feet)
Approx. 0.5 m - 1.0 m
(1.64 feet - 3.28 feet)
ISO400 Approx. 0.6 m - 2.4 m
(1.97 feet - 7.87 feet)
Approx. 0.6 m - 1.4 m
(1.97 feet - 4.59 feet)
ISO800 Approx. 0.8 m - 3.4 m
(2.62 feet - 11.2 feet)
Approx. 0.6 m - 2.0 m
(1.97 feet - 6.56 feet)
ISO1600 Approx. 1.15 m - 4.9 m
(3.77 feet - 16.08 feet)
Approx. 0.9 m - 2.9 m
(2.96 feet - 9.51 feet)
[HIGH SENS.] in
[SCENE MODE] (→45)
ISO1600-
ISO6400
Approx. 1.15 m - 9.8 m
(3.77 feet - 32.15 feet)
Approx. 0.9 m - 5.8 m
(2.96 feet - 19.03 feet)
[FLASH BURST] in
[SCENE MODE] (→46)
ISO100-
ISO3200
Approx. 0.3 m - 3.2 m
(0.99 feet - 10.50 feet)
Approx. 0.5 m - 1.9 m
(1.64 feet - 6.23 feet)
●
Do not touch or look at the flash (→7) from close distances (i.e. a few cm).
Do not use the flash at close distances to other subjects (heat/light may damage subject).
●
Flash settings may be changed when changing recording mode.
●
When [ ] is set in [SENSITIVITY], the ISO Sensitivity is automatically set in a
range up to 1600.
●
Scene mode flash settings are restored to default when scene mode is changed.
●
If flash is to be emitted, flash type marks (e.g. ) will turn red when shutter button is pressed halfway.
●
No pictures may be taken if these marks (e.g. ) are flashing (flash is charging).
●
Insufficient flash reach may be due to inadequately set exposure or white balance.
●
Flash effect may not be fully achieved with high shutter speeds.
●
Flash charging may take time if battery is low, or if using flash repeatedly.