Instructions for operations are generally
described using the remote control. (O 12)
1 Press [INPUT SELECT] and select “TV”,
then press [OK].
• If the Operator profile is being updated, a
different display may appear on the
screen. (O 30)
2 Press [CH W v] to select the channel.
• You can also select the channel by the
following operations.
- Using number buttons
- Using Channel List (O 28)
- Using TV Guide system (O 28)
- Using channel information (O 29)
If this unit request a PIN
Enter the PIN with the number buttons by
following the on-screen instructions.
• If you decide on a PIN, make a note it in case
you forgot it.
• PIN (except CAM's) can be changed via “PIN
Entry”. (O 99)
• For CAM's PIN, refer to your CAM's operating
instructions.
If encrypted channels do not appear
To watch an encrypted broadcast, insert the CI
module into the CI slot. (O 14)
• Set according to the CI module. (O 84, 95,
Common Interface)
To switch to the channel you have previously
watched
• This function will work only for the channels you
have watched for more than 10 seconds.
To switch to the radio channels or to the all
channels
Press [RADIO/TV].
CD
• Selection of channel is made easy by creating a Favourite
of the channels. 86, Favourites Edit)
• When you are watching the 3D programme, subtitles and
TV Guide, etc., may not display correctly depending on the
settings. 47, 48, 3D Type, Signal Format)
To Next Page
Loading...
