Panasonic Eco Solutions Nordic AB
MEW01622 Rev: - EBL128 Planning Instructions V2.0.x
161
COM loop units (input units, etc.)
Normal state
(quiescent) (mA)
Alarm state
(activated) (mA)
Analog smoke detector 2300 / 2304 + analog base 2312
141
Analog smoke detector 3304 + analog base 3312
142
Analog heat detector 3308 + analog base 3312xx
142
Analog heat detector, enclosed 3309
142
Analog multi detector 4300 + analog base 3312xx
142
Analog smoke detector 4301 + analog base 3312xx
142
Analog multi detector 4400 + analog base 3312xx
Analog smoke detector 4401 + analog base 3312xx
Addressable heat detector 2340 / 2341
141
Addressable zone interface, isolated 2226
145
Addressable IS zone interface 2821
145
Isolated zone interface 2822
Addressable zone interface 2335
Addressable manual call point 2333
Addressable manual call point 3333 / 3339
Addressable manual call point with isolator 4433 / 4439
Alarm Acknowledge Facility Control (AAFC)
146
Addressable detector base 2330 + detector
Incl. external line.
NOTE! On each COM loop, up to 5 sensors / detectors can have their LEDs lit at the same time.
External indicator (LED) current consumption. 2216: add 2 mA. 2217 /
2218: add 1 mA.
External indicator (LED) current consumption. 2216: add 2 mA. 2217 /
2218: add 1 mA.
Analog base with isolator 4313 can be used instead of Analog base 3312.
Plus 0.025 mA if green polling LED is used.
Plus 0.5 mA if External indicator (LED) is used (e.g. 2218).
2226 / 2821 also require external power supply, 24V DC, 30 mA.
This unit is available on the Australian market only.
Ext. LED current consumption max. 1 mA. Alarm state on detector and
external line: 15.4 mA. NOTE! The external line can be used for an ext.
indicator (LED) or for conventional detector(s) that will get the same
presentation number (zone-address) as the detector plugged in the base.