Panasonic EYFR03 - Assembly Object Connection Points

EYFR03 User Manual 82 of 110 v1.6.0
Chapter 7: EtherNet/IPTM 20 January 2020
Assembly Object Connection Points
This section defines the assembly object connection points provided by the EYFR03 product
line. As per the EtherNet/IP
TM
specification for the Assembly Object, instance number and
connection point are equivalent. This document will refer to them as connection point
throughout.
Output (O->T) Connection Points
The following connection points are used by the EYFR03 to take input data from the network.
These connection points allow you to control the running operation of the qualifier. Other
setting parameters may be configured through the vendor-specific objects.
160
Name
Data Type
Description
Item Number
UINT
Instance number of items to run. Deactivate any running parameter,
job, or group if 0.
Item Type
USINT
Type of item to run:
0 - Parameter
1 – Group
2 – Job
Ignored if Item Number is 0.
Batch Reset
USINT
When this value changes, the batch counts of the currently running
parameter or group is reset.
Suspend
BOOL
When set, suspends the unit without stopping a running parameter,
group, or job.
VIN
SHORT_STRING
Max length 100
Total size: 6-106 bytes
161
Name
Data Type
Description
Item Number
UINT
Instance number of items to run. Deactivate any running parameter,
job, or group if 0.
Item Type
USINT
Type of item to run:
0 - Parameter
1 – Group
2 – Job
Ignored if Item Number is 0.
Batch Reset
USINT
When this value changes, the batch counts of the currently running
parameter or group is reset.
Suspend
BOOL
When set, suspends the unit without stopping a running parameter,
group, or job.
Reserved
USINT
Padding byte for devices requiring even connection point sizes.
Total size: 5-6 bytes
162
Name
Data Type
Description
Item Number
UINT
Instance number of items to run. Deactivate any running parameter,
job, or group if 0.
Item Type
USINT
Type of item to run:
0 - Parameter
1 – Group