3-14
1
ON
23456
1
ON
23456
(3) Adjustment of the tamper bar swing range (continued)
RemoCheck the lighting condition of the
manual staple key.
Kept ON: Adjustment completed.
Blinking: Improper adjustment.
•Check the installation condition
of the guide bar home position
sensor, and repeat the
procedure from the step 3.
ve all the paper from the bin unit.
5
Turn OFF all the dip switch
(SW3: FA-S620, SW1:FA-S660)
6
(4) Adjustment of the staple position
Remove all the paper from the bin unit.
1
Detach the right cover and set the dip switch
on the sorter controller PCB as shown.
(SW3: FA-S620, SW1:FA-S660)
2
FA-S620
FA-S660
To Next Page
Loading...
