95
VQT3W38
Connecting with a HDMI mini cable
Select the desired method of HDMI output.
≥ [AUTO] determines the output resolution automatically based on information from the
connected TV.
If the images are not output on the TV when the setting is [AUTO], switch to the method
[1080p], [1080i] or [576p] which enables the images to be displayed on your TV. (Please
read the operating instructions for the TV.)
≥ Image will not display on TV for a few seconds in the following cases.
jWhen the 1080/50p recording mode is turned on/off during Motion Picture Recording
Mode
jWhen you touch the play mode select icon to select [1080/50p] and then touch [ENTER]
during Playback Mode.
jWhen the 1080/50p or 1080/50i scenes are switched.
Connecting with the AV multi cable
Select the desired setting of AV multi connector output.
Changing the component output setting
≥ Set [VIDEO LIGHT] to [OFF] when recording with the TV connected to the component
terminal to confirm the recording. (l 51)
: [SETUP] # [HDMI RESOLUTION] # [AUTO]/[1080p]/[1080i]/[576p]
: [SETUP] # [AV MULTI] # desired setting
[COMPONENT]: When connecting to the component terminal
[AV OUT]: When connecting to the video terminal
: [SETUP] # [COMPONENT OUT] # desired setting
[1080i]: When connecting to the component terminal on the TV compatible with
1080i.
(Playback is in high definition quality.)
[576i]: When connecting to the component terminal on the TV compatible with 576i.
(Playback is in standard quality.)
HC-V500&V500M-EB-VQT3W38_mst.book 95 ページ ２０１２年１月１３日 金曜日 午後９時４分
To Next Page
Loading...
