60
VQT3Y48
Switch the picture quality and recording format of the motion pictures to record.
*1 Recording will have higher quality in the order of [HA], [HG], [HX] and [HE].
*2 It can record with highest quality image in this unit.
*3 [iFrame] is a format suitable for Mac (iMovie’11). It is recommended for when using a
Mac.
≥ Recordable time using the battery (l 15)
≥ This function’s default setting is [HG] mode.
≥ Please refer to page 159 about approximate recordable time.
≥ When the unit is moved a lot or moved quickly, or when a fast-moving subject is recorded
(particularly when recording in [HE] mode), mosaic-type noise may appear at playback.
It is possible to continuously record motion picture to an SD card when there is no space
available in the built-in memory. (It allows you to record only to SD card from built-in
memory.)
≥ Set [MEDIA SELECT] to [Built-inMemory].
≥ Set [REC MODE] to [HA], [HG], [HX], [HE] or [1080/50p].
≥ Insert an SD card.
≥ is displayed on the screen. will disappear when space in the built-in memory is
gone and the recording to the SD card starts.
≥ Relay Recording can only be performed once.
≥ Combine the scenes that were relay-recorded using the [RELAY SCENE COMBINE]
into the SD card. (l 99, 111)
≥ Once you have performed [RELAY SCENE COMBINE], you can use the Relay Recording
function again. If the [RELAY REC] is set to [ON] without performing the [RELAY SCENE
COMBINE], a message is displayed. You will be able to perform Relay Recording by
touching [YES], but you will not be able to perform the [RELAY SCENE COMBINE] after
that.
[REC MODE]
: [RECORD SETUP] # [REC MODE] # desired setting
[HA]/[HG]/[HX]/[HE]
*1
: Set the recording mode to 1080/50i.
[1080/50p]
*2
: Set the recording mode to 1080/50p.
[iFrame]
*3
: Set the recording mode to iFrame.
[RELAY REC]
: [RECORD SETUP] # [RELAY REC] # [ON]
HC-V700M&V700_EB-VQT3Y48_mst.book 60 ページ ２０１１年１２月２６日 月曜日 午前９時３６分
To Next Page
Loading...
