Panasonic JU-253-T

To Next Page

To Previous Page

PART. 2 [JU-253-T]

12.

DISASSEMBLY

AND

REASSEMBLY

12.1 Removing and Remounting

the

Cover

(1) Remove

the

claws in

the

four

corners

the

cover

from

the

base

and

guide

plate

and

remove

the

cover.

(2)

remount

the

cover, clutch

the

claws

the

four

corners

the

cover from

the

outside.

Cover

Guide Plate

(Left)

,,.---/~/

\./

Fig.12-1.

RemovingtheCover

12.2 Removing and Remounting

the

Front Panel

Assembly

(1) Remove

the

two

claws on

the

left

side

the

front

panel

from

the

left

side

guide

plate,

remove

the

two

claws on

the

right

side

from

the

right

side guide plate and remove

the

front

panel.

(2)

Remount

the

front

panel

the

reverse

procedure

step (1)

that

the

button

inserted

into

the

button

hole

the

front

panel.

Front Panel Assembly .

Fig. 12-2. Removing

the

Front Panel Assembly

- 15 -

12.3 Removing and Remounting

the

Guide Plates

(1) Remove

the

cover and

front

panel according

the

procedures in sections

12.1

and 12.2.

(2) Remove

two

set screws

the

right

side guide

plate.

(3)

Lift

the

right

side

guide

plate

that

removed from

the

roller

pinched by

the

recess

the

guide plate and remove

the

right

side

guide

plate

through

the

path

between

the

eject lever and

the

base.

(4) Remove

the

left

side

guide

plate in

the

same

manner

above.

(5) Remount

both

plates in

the

reverse procedure

steps (1)

(4).

A-Guide

Plate (Left)

: Guide Plate (Right)

~~~

-'\)

r,j

JEjectlever

:t:::~

"':;.

Roller

Fig. 12-3. Removing

the

Guide Plates

12.4 Removing and Remounting

the

Holder

Assembly and Rollers

(1) Remove

the

guide

plates

according

the

procedure in section 12.3.

(2)

Lift

the

holder

assembly by hands and

gently

slide

toward

you,

then

the

four

roller sections

the

holder

will

be removed

from

the

eject

levers. { Keep in mind

that

the

rollers

drop

easily.) In this

case,

when

the

side 1

the

head assembly drops

from

the

holder,

strikes

the

head on

the

side 0 being pushed by

the

side

1 head retaining spring,

lift

lightly

the

thumb.

(3) Remove

the

four

rollers

from

the

holder

assembly.

(4) Remount

the

rollers

and

holder

assembly in

the

reverse procedure

steps (1)

(3).

Main Page

Table of Contents

Related product manuals