Panasonic JU-253-T

12.9 Removing and Remounting the Trigger Lever
Assembly
(1) Remove the cover according to the procedure
in section 12.1.
(2) Remove the trigger lever set screws and
remove the trigger lever spring and trigger
lever assembly.
(3) Remount the above in the reverse procedure of
steps (1) and (2).
Fig.12-9.
Removing the Trigger Lever
Assembly
12.10 Removing and Remounting the Eject Lever
Springs
(1) Remove the holder assembly according to the
procedure in section 12.4.
(2) Remove the hook of the eject lever spring and
remove the eject lever spring.
(3) Remount the eject lever spring in the reverse
procedure of steps (1) and (2).
[Cautions for Remounting]
(4) Remount the front hooks on the base so that
both of them on the right and left sides are
faced inward.
(5) Place the eject lever springs so that their coiled
portions are faced rearward.
- 18 -
Eject lever spring
Fig. 12-10. Removing the Eject Lever Spring
12.11 Removing and Remounting the Eject lever
(1) Remove the eject lever springs according to the
procedure in section 12.10.
(2) Remove the trigger lever assembly according to
the procedure in section 12.9.
(3) Remove the four stopper rings and washers
from the eject lever.
Each stopper ring has ·a slit, so it can be easily
removed by pinching the portion adjacent to
the slit by tweezers.
(4) Remove the eject lever.
(5) Remount the eject lever in the reverse
procedure of steps (1) to (4).
Fig. 12-11. Removing the Eject lever